CCVSD - OXYGEN FOR 801307 OXY BREATHING EQPMT

Product Identification

Product ID:OXYGEN FOR 801307 OXY BREATHING EQPMT
MSDS Date:02/01/1989
FSC:1660
NIIN:01-014-0576
MSDS Number: CCVSD

Responsible Party
SCOTT AVIATION DIV. OF FIGGIE INTL. INC.
225 ERIE ST
LANCASTER, NY 14086
US

Emergency Phone: 716-683-5100

Info Phone: 716-683-5100/FAX 716-681-1089

Cage: 53655

Contractor
SCOTT AVIATION
LANCASTER, NY 14086 US

Telephone: 716-683-5100

Cage: 53655

Ingredients

OXYGEN

CAS: 7782-44-7

RTECS: RS2060000

Fraction By Weight: 100%

Hazards

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:OXYGEN NONTOXIC UNDER MOST CONDITIONS
OF USE,NECESSARY TO SUPPORT LIFE.LIQ OXY/COLD GAS FREEZE
TISSUES,CAN CAUSE SEVERE CRYOGENIC BURNS.BREATH PURE OXY @1ATM
PRODUCE COUGH,CHEST PAINS.PARTIAL PRESS OF OXY >2ATM PRODUCE VAR
OF CNS MANIFESTATIONS(FINGER/TOES TINGLE,VISUAL/HEAR DISTURB,ABN
SENS,IMPAIR COORD,CONFUS,(SUPPL)
Explanation of Carcinogenicity:PER MSDS:NOT LISTED AS CARCINOGEN BY
NTP/IARC/OSHA.
Effects of Overexposure:FREEZING TISSUES, SEVERE CRYOGENIC BURNS, CHEST
PAINS, CNS AMNIFESTATIONS, CONFUSION, IMPAIRED JUDGMENT.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid

First Aid:IF CRYOGENIC LIQ/COLD BOIL-OFF GAS CONTACTS SKIN/EYES FROZEN
TISSUES SHOULD BE FLOODED OR SOAKED W/TEPID WATER(105-115F).DO NOT
USE HOT WATER.BURNS WHICH RESULT IN BLISTERING/DEEPER TISSUE
FREEZING SH OULD BE SEEN PROMPTLY BY PHYSICIAN.

Fire Fighting

Autoignition Temp:Autoignition Temp Text:NA
Lower Limits:NA
Upper Limits:NA
Fire Fighting Procedures:OXY NON-FLAMM BUT SUPPORTS & VIGOROUSLY
ACCELERATES COMBUSTION OF FLAMM.SHUT OFF SOURCES OF OXY & FIGHT
LIKE CONVENTIONAL FIRE.
Unusual Fire/Explosion Hazard:OXY NON-FLAMM BUT SUPPORTS & VIGOROUSLY
ACCELERATES COMBUSTION OF LAMM.SOME MATLS WHICH ARE NONCOMBUST IN
AIR WILL BURN IN PRESENCE OF OXYGEN.

Accidental Release

Spill Release Procedures:PREVENT CONTACTING
GREASE,OIL,ASPHALT,COMBUST.VENTI TO EVAPORATE/DISPERSE OXY.FLUSH
W/LG QUANT OF WATER.DON'T ENTER AREA OF HI OXY CONC-SATURATE
CLOTH,INCR ITS FLAMM.AVOIDI SMOKING/CONTACT W/IGN SOURC E AFT EXPO
TO CONCEN OXY HIGHER THAN NORM ATM.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:PREVENT ENTRAPMENT OF LIQ IN CLSD
SYS.ESSENTIAL-CLEANLINESS/COMPATIBLITY OF MATL W/OXY.HNDLG
COMPRESSED OXY CYL W/CARE.USE PRESS-RED REG WHEN(OTH PRE)
Other Precautions:CONNECT TO LOW PRESSURE SYS.SECURE CYL.NEVER USE
DIRECT FLAME TO HEAT CYL.USE CHECK VAL-PREVNET BACKFLOW INTO
CNTNR.AVOID DRAG/FROLL/SLIDE CYL-USE SUITABLE HD TRUCK.DON'T STORE
OXY CY W/IN 20FT OF FLA MM/COMBUST MATL.AVOID CORR AREAS(SUPPLE)

Exposure Controls

Ventilation:PREVNET ACCUM W/NAT/FORCE AIR.LOC EXHA/MECH(GEN):AS
NECESSARY.SITUATE VENTS TO AVOID HIGHER THAN NORM CONC OXY IN
WORKAR
Protective Gloves:LIQ:LOOSE-FIT,IMPERM MATL(LEATHER)(SUPP)
Eye Protection:CHEM GOGG,SAF GLASSES.
Work Hygienic Practices:PREVENT SKIN CONTACT.USE ONLY IN WELL VENTI
AREA.SEE COMPRESSED GAS ASSOC PAMPHLET P-1 FOR ADDN STORAGE
RECOMMENDATIONS.
Supplemental Safety and Health
HEALTH HAZ:MUSCLE-TWITCH,SEIZURES LIKE EPILEPSY).SEVERE HAZ PRESENT
WHEN CONF/IMPAIR JUDGMENT LEAD TO OPERATIONAL ERRORS. DISPO:AIR
PRODUCTS W/RESIDUEAL PRESSURE/CYL VAL TIGHTLY CLSD/VAL CAP IN
PLACE. OTHER PRECAUT:DON'T SUBST OXY FOR COMPRESSED AIR.USE ONLY
W/EPQMT SPEC DESIGN/CLEAN FOR OXY GLOVES:GAS:LEATHER WORK GLV

Chemical Properties

HCC:G4
Boiling Pt:B.P. Text:-297F,-183C
Melt/Freeze Pt:M.P/F.P Text:-362F,-219C
Decomp Temp:Decomp Text:NP
Vapor Pres:NA
Vapor Density:0.08279
Spec Gravity:1.10 @68F/1ATM
pH:NP
Viscosity:NP
Evaporation Rate & Reference:NP
Solubility in Water:3.16% @77F/1ATM
Appearance and Odor:GASEOUS OXY IS COLORLESS,ODORLESS.LIQ OXY IS PALE
BLUE & ODORLESS.
Percent Volatiles by Volume:NP
Corrosion Rate:NP

Stability

Stability Indicator/Materials to Avoid:YES
ALL FLAMMABLES, ESPECIALLY PETROLEUM PRODUCTS.ASPHALT,OTHER VOLATILE
FLAMMABLES.
Stability Condition to Avoid:MATLS WHICH BURN IN AIR WILL BURN
VIOLENTLY IN ATM RICHER THAN APPROX 25%OXY.SOME MATLS ARE NONFLAMM
BUT BURN IN PURE O2
Hazardous Decomposition Products:NONE.

Disposal

Waste Disposal Methods:ALLOW LIQ OXY TO EVAPORATE IN WELL VENTI OUTDOOR
AREA.VENT TO OUTSIDE LOCATION.DISPO SITE SHOULD BE REMOTE FROM
WORKAREA,OPN FLAME,IGN SOURCE,COMBUST.FLUSH W/WATER WILL INCR
VAPORIZA RATE.DON'T ATTEMP T DISPO RESIDUAL OXY IN COMPRESS
CYL-RETURN(SUPPL)

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.